Dryer Vent Cleaning in Aldine, TX

Frequently Asked Questions

The vent hood on my outside wall is rusted and the flap barely moves. Do I repair that or replace the whole thing?

Nine times out of ten in Aldine it's a replacement, and it's a small one. These houses have the hood mounted low on the exterior wall, often only a foot or two off the ground, so it takes years of splashback, humidity, and road grit off the corridor. The metal flap corrodes, the hinge seizes half-open, and then lint stops exiting and starts packing the last stretch of duct instead. If the hood body is solid and only the flap is stuck, we can sometimes free and clean it during the service. If the housing itself is rusted through or crushed from a mower or trash can, a new hood is the honest answer. Patching one that no longer seals just recreates the same clog.

What actually goes wrong with dryer vents in this part of north Harris County?

Three things, usually together. First, the runs are short (garage corner, rear utility closet, or a carport wall straight out the back), and short runs with little or no rise let lint settle instead of carrying out. Second, most of these 1950s-70s houses still have the original flexible duct, which sags between the dryer and the wall and traps lint at every low spot. Third, the Gulf humidity plus the dust coming off the freeway and the industrial yards turns loose lint into a dense, damp mat that a shop vac won't touch. The result is a vent that looks fine from the outside and is nearly solid an inch behind the hood.